At4 Rocket Price - The M136 AT4 is a lightweight, self-contained, anti-armor weapon. It consists of an expendable, one-piece, fiberglass-wrapped, free-flying, wing-stabilized, rocket-type cartridge packed in a tube. The AT4 is man-portable and fired only from the right shoulder. Since the M136 AT4 was issued as a bullet shell rather than a gun, the launcher is completely sealed.
The AT4 was designed in the late 1980s for use against the enhanced armor of light armored vehicles. Although the AT4 is primarily used as an anti-armor weapon, it can be used with limited success against secondary targets such as gun emplacements, bunkers, buildings or light vehicles.
At4 Rocket Price
The launcher is waterproof for easy transport and storage. Unlike the M72 series LAW, the AT4 launcher does not need to be extended before firing.
Model Parts For Shoulder Held Rocket Launcher At4 M136 Anti Tank Usmc Us Army
The cartridge consists of a flap assembly with a follower element; Point Initiating, Base Detonating, Piezoelectric Detonators; A linear warhead body; and a precisely shaped explosive charge.
The AT4's warhead has excellent penetration and lethal post-armor effects. Highly destructive, the 15.5 ounce (440 g) explosive penetrates more than 14 inches (356 mm) of armor.
When the gun is fired, pressure builds up in the chamber and breaks the baseplate. When the baseplate breaks, gases escape from the rear of the gun, causing a rear detonation.
The total blowback area extends 328 ft (100 m) to the rear of the launcher on a 90° fan. Heat or flying debris from the rear blast can injure the shooter and other soldiers anywhere in the rear blast area.
These Are All The Types Of Shoulder Fired Missiles That Are Pouring Into Ukraine
The AT4 can penetrate more than 17.5 inches (450 mm) of armor plate. The warhead delivers powerful devastating effects behind armor. Testing against typical urban targets is still ongoing, but the AT4 should pierce at least as well as the 90mm recoilless rifle, if not better.
The AT4 has a minimum weapon range of 33 feet (10 m), allowing it to successfully fire at close targets. The detonator should be well protected by protective equipment when firing at close targets.
AT4 will only cause a small penetration hole on an armored vehicle target, but may cause some fragmentation or fragmentation.
The AT4-Confined Space (CS) gun is a safety improvement of the M136 AT4 multipurpose gun, significantly reducing the gun's recoil and launch signature, allowing the gun to be safely fired from a chamber or other protected enclosure. The AT4-CS will remain the US Army's primary shoulder-launched, lightweight, anti-tank weapon. This article is about the Swedish unguided anti-tank gun. For the guided anti-tank missile of the Soviet Union/Russia, see AT-4 spigot.
Army Tests Training Rounds For Shoulder Launched Weapon
It is a Swedish-made 84 mm (3.31 in) unguided, man-portable, disposable, recoilless anti-tank weapon manufactured by Saab Bofors Dynamics (formerly the Bofors Anti-Armor System and earlier the FFV command).
The AT4 is not considered a rocket launcher, as the explosive warhead is not propelled by a rocket engine; Similarly, it is not a recoilless rifle, but a recoilless gun because the launcher is straight bore and not a rifle.
Saab achieved significant sales success, making the AT4 one of the most common light anti-tank weapons in the world.
The name AT4 is a pun on the gun's 84mm caliber, (84) a synonym for "A-T-4" being "charasi".
Gmc Acadia Discount Drops Price By $4,000 In May 2020
Since "AT" is a common military abbreviation for "anti-tank," the name also doubles as an alpha-phonetic pun on the weapon's role.
The name was coined for export purposes, as the nickname "fourty" was already a common bright nickname for the Carl Gustaf 8.4 cm recoilless rifle after its caliber.
The AT4 is intended to provide infantry units with a means to destroy or disable armored vehicles and fortifications, but is generally ineffective against existing modern main battle tanks (MBTs), especially those with reactive armor, unless the weaker parts of the tank's armor are exploited. The launcher and projectile are manufactured pre-packaged and supplied as a single ammunition unit, the launcher being discarded after a single use.
(Miniman) was adopted by the Swedish military in the late 1960s. Like the m/68, the AT4 was designed by Förade Fabriksverk (FFV) and built at their facility in Karlstad, Zakrisdal, Sweden.
Brain Injuries And Shoulder Launched Assault Weapons
FFV began researching a weapon to replace the m/68 in 1976 and deliberately developed an individual anti-armor weapon, believing that it would not be able to defeat the heavy armor protection of MBTs (main battle tanks) on the frontal armor and reverse fire AT4 design. Medium and light armored vehicles from any direction, MBTs from the side or rear, and were intended to measure as an offensive weapon against buildings and fortifications. The FFV's weapon design also had targets that were easier to use, stronger, and more accurate against moving targets than previous personal anti-armor weapons. Another important requirement was that the AT4 could not only penetrate armor, but also have a devastating trans-armor effect after fragmentation. The FFV and the Swedish Army launched the first evaluation shots of the prototype AT4 in the spring of 1981, 100 of which were tested in early 1982.
Before Sweden adopted the AT4, it was included in a US Army competition for a new anti-tank weapon mandated by Congress in 1982, and the FGR-17 Viper failed to replace the M72 LAW. In 1983, six guns were tested by the US Army: the British LAW 80, the German Armbrust, the Frch APILAS, the Norwegian M72E4 (modified M72 LAW), the US Viper (for basic comparison purposes) and the Swedish AT4. The US Army reported to Congress in November 1983 that the FFV AT4 came closest to meeting all of the basic requirements set to replace the M72 LAW.
While very impressed with the simplicity and durability of the tested version of the AT4, the US Army saw some room for improvement, notably the addition of rear and front bumpers to the launch tube and changes to the sights and suspension. After these modifications, the AT4 was adopted by the US Army as the light multipurpose weapon M136.
The Swedish military also took note of these improvements and later adopted an Americanized version of the AT4 as the Pansarscott m/86 (Pskott m/86) and added a forward folding hand grip to help stabilize the AT4 when aiming and firing. The only difference between the Swedish adopted AT4 and the US Army version is the forward folding clutch.
Could Ukraine Run Out Of At4 'tank Killer' Missiles?
Due to the urban warfare conditions that US military forces routinely faced during the Iraq War, the US Army Close Combat Systems Manager responsible for AT4 procurement suspended orders for the standard version of the AT4, and US military forces now only order the AT4. CS (closed space) version.
This section requires additional citations for verification. Please help improve this article by adding citations to reliable sources. Weldless material can be probed and removed. (November 2021) (Learn how and when to remove this template message)
The AT4 can be considered a disposable, low-cost alternative to the Carl Gustaf 8.4 cm recoilless rifle. The AT4 borrows many of its design features from Carl Gustaf, operating on the principle of a recoilless weapon in which the forward inertia of the projectile is balanced by the inertia of the propellant ejected from the rear of the barrel. However, unlike Carl Gustaf, who used heavier and more explosive steel pipes with grooves,
The disposable AT4 design greatly reduces manufacturing costs by using reinforced ribless fiberglass outer tubing. Being a disposable gun also allows for a lighter and cheaper build. In a single-use single-use weapon, the barrel must have a single pressure surge that can be destroyed during firing, even if it is destroyed, burned, and stretched, requiring it to survive multiple pressure surges without failure, as in a conventional weapon. Therefore must be heavily overbuilt and made of heat-resistant materials. Pressure is also kept low compared to most conventional pistols. This light and thin barrel and low pressure, combined with the almost complete lack of recoil, meant that relatively large projectiles (compared to those found in mortars and artillery) could be used that would otherwise be impossible in a man-portable weapon.
M136 At4 Rocket Launcher
In the system originally developed by FFV for Carl Gustaf, a plastic detonation plug is placed in the center of the shell casing containing the projectile and propellant, which itself is enclosed in an AT4 outer tube. When the gases reach the correct pressure level, the bleed plug ruptures, allowing the correct amount of gas to be forced back, balancing the propellants pushing the projectile forward.
The AT4 uses a unique method previously developed by FFV and adopted for the AT4: a spring-loaded firing rod is located on the side of the outer tube, with the firing pin located behind the tube. When released, the firing pin strikes the detonator on the rim side of the sleeve.
The disadvantage of a recoilless design is that it creates a large recoil zone behind the gun; This can cause severe burns and overpressure injuries to unruly personnel in the user's vicinity and sometimes
At4 price, at4 rocket launcher for sale, at4 rocket for sale, at4 rocket launcher prop, at4 rocket, at4 rocket launcher tube for sale, gmc sierra at4 price, at4 rocket cost, at4 rocket launcher price, at4 rocket launcher cost, used at4 rocket launcher for sale, at4 rocket launcher
0 Comments